Click the Main button to open the Main Panel. Here, you’ll find several basic parameters for editing Loops.



Volume – Turn this knob to increase or decrease the volume of the Loop. It is measured in decibels.


Pan – Turn this knob to shift the sound of the Loop to the left or the right. It is measured in relative distance from the center point.


Attack – Turn this knob to increase or decrease the amount of time it takes the Loop to reach its highest volume. It is measured in milliseconds.


Release – Turn this knob to increase or decrease the amount of time it takes the Loop to stop playing once you have released the note. It is measured in milliseconds.


Crossfade – This knob applies a fade between the Loop start and Loop end points to avoid potential clicks. You can dial in the fade amount in milliseconds with the knob.