Macros

Assign MACROS by dragging and dropping colored MACRO indicators ( + ) onto a knob. 

Set MACRO DEPTH by clicking and dragging on the MACRO circle beside the assigned knob.

mceclip0.png

 

Right click on an assigned MACRO circle to change MACRO to BIPOLARUNIPOLAR, or to REMOVE MACRO

mceclip1.png

 

Right-click a MACRO knob to RESET to default, and remove all assignments. MACROS take on the current knob position as the zero point of modulation. 

 

Change the zero position for MACRO DEPTH depth by shift + click and dragging up or down on the assigned MODULATION circle.

Was this article helpful?
5 out of 6 found this helpful

Articles in this section

Our support hours:
Mon - Fri 6:00a.m. - 6:00p.m. PST Sat - Sun 7:00a.m. - 6:00p.m. PST